QUOTE
This screen enables you to set Wi-Fi Protected Setup (WPS) parameters for easy install wireless communications.
WPS: Enable/Disable Wi-Fi Protected Setup function.
Status: Display the state ( Un-configured State / Configured State ) information of WPS .
Self-PIN Number: Display the default PIN number of AP.
Client PIN Number: Type Client PIN number the client uses to negotiate with AP via WPS protocol. It is only used when users want their station to join AP's network.
Push Button Configuration: Clicking this button will invoke the PushButton Configuration (PBC) method of WPS . It is only used when AP acts as a Registrar .
WPS: Enable/Disable Wi-Fi Protected Setup function.
Status: Display the state ( Un-configured State / Configured State ) information of WPS .
Self-PIN Number: Display the default PIN number of AP.
Client PIN Number: Type Client PIN number the client uses to negotiate with AP via WPS protocol. It is only used when users want their station to join AP's network.
Push Button Configuration: Clicking this button will invoke the PushButton Configuration (PBC) method of WPS . It is only used when AP acts as a Registrar .
So... I'm trying to set up a password/protection (whatever) for my Wi-Fi and i'm not very smart so i'm trying to figure out how and these words hurt my brain. First I don't know what a "Client PIN number" is, so that doesn't help me
There was also one that said (Security) so I have no idea which one is the right one...
QUOTE
Security
Authentication Type Disable WEP WPA WPA2 WPA-AUTO
WEP Open System Shared Key
Mode HEX ASCII
WEP Key 64-bit 128-bit
Key 1
Key 2
Key 3
Key 4
Authentication Type Disable WEP WPA WPA2 WPA-AUTO
WEP Open System Shared Key
Mode HEX ASCII
WEP Key 64-bit 128-bit
Key 1
Key 2
Key 3
Key 4
The Key whatever was like "0000000000" so, uh....
Anyone have an idea of what I should do? 'Cause I wanna have more secure Wi-Fi ...
Thanks!
Edit: it's a TRENDNET TEW-652BRP
Edited by ShippudenGirl, 16 April 2011 - 01:10 AM.